Kundenbewertungen für VEVOR 4x Panzerrollen 12T Transportfahrwerk 280x210x105mm Transportrollen mit 4 Richtungsräder aus Kohlenstoffstahl Industrieroller Roller Ф 135x9mm Drehplatte Möbeltransporthilfe Transportroller

Just buy Vevor and you won't be sorry!!

Très robuste Essayer sur des machines 4 tonnes environ sur plusieurs mètres. Impeccable. Nécessité d’avoir un sol plat, sans défaut et bien lavé. La moindre imperfection n’est pas très appréciée par les rouleaux mais c’est tout à fait logique. Acheter les yeux fermés.

They were awesome for moving my CNC 8000 lbs, Warning though MOVE machine slowly on dollys. If floor is uneven one can slide out and machine can tip. Otherwise they make the work easy.

Ottimo prodotto, robusto e facile da usare. l'unica pecca è che hanno bisogno di pavimento solido in cemento liscio, non vanno bene su asfalto o pavimento molto ruvido

Let me start with the problems with this product.1. The top 5.5 inch steel disc on each skate is slippery.2. The top discs are flat, allowing your moved item to slip off the disc. It should have shoulders on edge.3. The skates turn independently of each other when you push.4. There is no rubber disc to prevent slippage as you might expect.First try moving my mill:This product is certainly heavy duty. I put my 3000 pound mill on 4 of the skates. I had to change to 3 skates because my concrete is not flat enough and one of the skates kept slipping out. The bottom of the mill is flat cast iron. The "non-slip" surface of the skate is a flat steel disc with some grooves cut in it. I wouldn't call this non-slip. There is no rubber pad as you might expect, not even little tabs around the edge of the round top disc like a floor jack has to keep the mill from sliding off the disc. I almost had one slide out from under the machine.Second try:I've seen videos where they use these and I can tell you that it's not that easy. I put a rubber pad on the skate to see if that helped and it did. The problem now is that when I push the mill, each skate turns independently of the other and when they do, the mill stops rolling. I noticed in the videos that there are usually 2 guys pulling with a bar hooked on to two skates. I can see where that would help,, but the two skates in the back are still going to turn independently of each other.Third try:I solved the problem with the rear skates turning independently of each other by connecting them with a steel rod. That did work and the skates more or less stayed under the machine with the rubber pad. Any way you look at it though, you're going to need more than one guy to use these things, if you can get them from turning independently at all.Fourth try:Now, having moved the mill 2 feet in the last hour, I have to turn it to get it where I need it. The problem is that again, the skates turn independently and also, the pad o

I haven’t tried these yet. I don’t think they will lift 3 tons each. Word of advice though is if VEVOR say they will deliver on a date then add another week. They are terrible with their shipping and take no responsibility. I have also ordered a diesel heater which they say takes slightly more than 2.5A. Turns out it needs 20A! Had to order a whole new power supply which cost more than the heater. VEVOR can be trusted on their word.