Kundenbewertungen für VEVOR 305mm Betonsäge Trennschneider Pflasterschneider Betonschneider 2800W

I contantly blew a 20 amp breaker. We needed to switch to a 30 amp breaker to run saw. It was blowing the 30 amp breaker but ́ot as often. Then the in line reset on the saw cord got very hot. After cutting that off cord and replacing the end the saw ran great. No more problems with blowing the breaker

saw cuts well not a fan of the water hookup should have a hose connection instead of that mickey mouse pump you have to put in a bucket of water. also dont think thats very safe

This thing is a beast. requires a 20 amp circuit to run it and it will trip your 20 amp circuit after a continuous 5-10 minutes of usage if you release the trigger and it goes through start up again the circuit pops for sure. But it gets the job done. Overall, it’s a good purchase.

I believe the motor and casing is sound, the blade that comes with the machine is warped and not usable, I will have to purchase one that will actually work without throwing the saw everywhere or rub against the guard.

water supply line broke upon unpacking. had to replumb it............................................................................................... frustrating.

Best way to put it : value and ease of use. And great option when gas tools are not alowed in the facility. Only draw back is amp draw required for the wet saw Found most locations i have used it i strugle with tripping the breaker most home owners dont have 20 amp exterior recepticals So we have to run the generator on the tool trailer.

saw works good but will trip breaker frequently. need heavy ext cord and atleast 30amp breaker. it did work as described. it is a pain to have 2 ext cords. 1 to run saw. 1 to run water pump

Did the job however needs more than 20 amps to run for more than 5 minutes at a time. Does shut down as it heats up so had to make multiple shallow cuts but all and all did the job I used it for which was to cut a door in a foundation wall.

I rubtured a disc in my back so I haven't even took it out of the box. I have purchased from vendor multiple times. All purchases have been fine, I am confident this purchase will be too. I will review again when my back heals.

Only downfall is after cutting until it heated up and went into protect mode. Let it cool down for 20 minutes then went back to cutting seemed to get hot again quicker but was able to make the cuts I needed. So highly recommend this