Kundenbewertungen für VEVOR 2x Palettengabeln Anklemmbar 1490x100x230 mm Gabelträger 1814kg Tragfähigkeit Gabelzinken 149cm Gesamtlänge mit 109,2cm-Gabelblatt Gabelstapler Gabelstaplerzinken Frontlader Palettenrahmen

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

They are a little flimsy but work ok for what I need to do.

They are a pain in the A## to use, always slipping, even with a plate under the hold down area, they bent my bucket. I will be welding them permanently to a plate

Was moving rafters and some how bent one of the blocks that tighten it down with my 35 hp tractor

I was disappointed when I got these. The pads used for the mounting screws are just nuts loosely threaded on. When you go to tighten them, the nuts spin on the screw and will move up. When you loosen, the nuts fall right off. Very cheap design. If you are putting the forks on one time and leaving them, it would be okay. But if you are constantly taking them on and off, it is a big deal.

I did t rate it hi because its not strong enough for my use. If you're just going to make straight pics its fine but it twists easily and comes apart easy. I will find a stronger one. I wasted my money on this one

I tried these forks on the bucket of my tractor. They were very hard to tighten and grab the Steele of the bucket. Once tight, they became loose again.

I would not recommend these. The the bolts are soft and had my first use. They actually bent. Those need to be re-engineered with something stronger. Really can't use them for pallet work. They just don't have the ability to stay on the bucket good enough for any amount of weight, but that's significant. Now they are handy for hand stacking things like 2x4s, small logs etc. But in no way replacement for actual pallet forks to be used as a tractor

The 3 point hitch pallet fork might actually work well, but I wouldn’t know because the box was so destroyed by ups when I received it that all the hardware pins were missing. I’m sure they are rolling around in the back of an ups truck somewhere, but that doesn’t do me any good. I’ve contacted VEVOR twice about this and was told both times someone would contact me within 24 hours, but I have yet to hear from anyone.

Broke first use - the tab holding the pin for 3pt hitch folded while sliding the forks into a pallet. The original welds didn't penetrate the metal.