Kundenbewertungen für VEVOR 2x Palettengabeln Anklemmbar 1090x70x230mm Gabelträger 907kg Tragfähigkeit Gabelzinken 109cm Gesamtlänge mit 76,2cm-Gabelblatt Gabelstapler Gabelstaplerzinken Frontlader Palettenrahmen

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

If I had it to do all over I would bought the ones that are connected but I just welded a piece of pipe to mine. They serve there purpose but the will shift one you no matter how tight you get them.

Quality of steel forks are really good but the center likes to pop out sometimes. If they made the center a little more steady it would be pretty good product.

Received the item and the bolts needed for the lower link were missing instead there were pins. This absolutely is incorrect I had to buy additional bolts to use for the lower link

I found the forks absolutely useless and a complete waste of money!!! First, I had to file the divider down to fit it over the forks. Second, When I tightened the bolt to keep the divider at a constant width, it snapped quite easterly and Third, The forks wouldn't stay tight on the FEL bucket, it didn't matter how tight I initially tightened them. Typical CHINESE RUBBISH, I should have known better. I would be VERY hesitant to buy anything from Vevor again.

The product arrived and is what was expected. But, much to my dissapointment only half ot the required hardware, 2 of the 4 nessecary 20mm bolts, were included. When I coresponded with Vevor Customer Service, and asked to have those bolts sent, I was told that Vevor did not have them, nor could they procure them, and I was offered a partial refund. I took the refund, and eventually did find the proper 8.8 Grade bolts, but as I was required to invest my time and effort, my frustration over this purchase grew, hence the 2 of 5 star rating.

They are a little flimsy but work ok for what I need to do.

It was built really well but they never put the screw rods in the package and you need those to stabilize the forks on whatever you mount them to, and they wouldn’t send me replacements