Kundenbewertungen für VEVOR 274 cm Führungssystem für Tragbares Sägewerk Kettensägenmühle Kettensägewerk Führungsschiene aus Aluminium- und Eisenmaterialien kompatibel mit verschiedenen Kettensägen und Kettensägenmühlen

Has replaced a rusty homemade guide rail system which was unwieldy. Very simple and easy to set up. looking forward to doing some milling (Stihl Magnum 660)

Ich hatte mir für den Preis eigentlich nichts Großes versprochen und da ich es nur für einen großen dicken Stamm benötigte. Dafür war der Preis sehr in Ordnung...Aber zu meinem Erstaunen erwies sich diese Schiene als sehr zuverlässig, so das ich sie schon einige Male an Nachbarn verliehen habe...alle waren zufrieden. Ich habe mir noch eine zusätzliche Zugvorrichtung mit Kurbel angebaut was das Sägen ungemein erleichtert.

Finally bought and I'm very happy with it. It's a quality built item and is easy to use. Fast shipping as always

Works as intended. Great price!

Good product for smaller home projects.

I use this rail system for some small scall timber salvage. It is quick and easy to handle by one person. I had a bit of an issue getting the units to level out at the joins but once it was all straightened out is holds level and works great. I don't use the lag bolts that came with it, I made up some leveling and hold down spikes from some 5/16 all thread double nutted through the holes in the cross members. Works better.

Works as it should. Takes a bit of fiddling to level. I added parts two kits together to make longer planks without any problems.

Zu gering dimensioniert die Profile. Die Schiene biegt sich insgesamt zu weit durch. Man muss bei einem gebogenen Stamm zu viel unterkeilen.

I have tried making a couple of cuts with it so far and both times the leveling bolts started to blackout as I cut. So as the cut progressed the saw would cut lower and lower and I didn't notice it until the saw couldn't proceed past the backed out adjusting screw. Which I had to screw down further to get past it but by then the slab had a bow cut into it. I going to have to buy some nuts to use as jam nuts to see if I can prevent this from happening again.

I will start by saying that I have used this product a handful of times and it has done its job. I purchased the vevor chainsaw mill as well. It works well, cuts true, but the nuts they use to hold each section together should be locking. The vibrations for the milling process worked a few of the nuts out and have now returned to the forest. Also the toll they give you is similar to your chainsaw tool, but it is made of very weak metal. When tightening the nuts the tool broke.