Kundenbewertungen für VEVOR hydraulische Werkstattpresse 20 t (H-Rahmen) mit Pressplatte & Dreieckstütze, einstellbare Hydraulikpresse mit Überdruckventil (Max. Zylinderhub 145 mm), zum Biegen & Richten & Stanzen

got the job done. Had to make a few extensions as I was pressing out a long heat exchanger from a casing but it worked just as intended and saved me big bucks as the press was one tenth the cost of a new heat exchanger

Taitaa olla markkinoiden halvimpia prässejä. Toimii hyvin mihin nyt 6 tonnin voima riittää. Pullotunkin voi varmaan vaihtaa isompaan ja hitsata vahvikkeet jos voima loppuisi kesken.

It needs a few modifications .......................................................................

I had to weld the bottom of the bottle jack to the cross section so it wouldn't slide off in use. Works well otherwise.

I really liked everything about with the exception of the actual jack. It takes a lot of pumps to get the thing to move and yes the valve was closed tight. It still worked for the small job but doubt it can really provide 12tons of pressure. I will end up replacing the jack as I like the rest of the setup.

tres bien mais pour les petite bricole

Sai vaihdettua pyöränlaakerin, mut vähän haasteita oli, kun on niin pieni prässi.

Il prodotto é ok mancavano solo i due Pin per l'appoggio delle barre trasvrrsali un vero peccato se no sarebbero stati 5 stelle compöete

Most issue i have is with the platform, could've made it one solid piece instead of split held together with 2 bolts. When you tighten the bolts, the platform essentially becomes a clamp and you cant just pull the pins to move it up or down, have to loosen bolts first, adjust then retighten bolts. Also could've slanted the metal guide brackets on the top press that guides it on each side. There's about a 1/4" gap on both sides and when go to press, itll not he centered, so you have to pump the handle while guiding the top portion.

Tis was just what I need to press in some bushings. The thing I like about is you can change out the hydraulic jack to something with more capacity. I'm thinking maybe a 10 ton. The jack handler is a little short but I used a longer one I had and it made it much easier.