Kundenbewertungen für VEVOR 3-Backen-Drehfutter, φ200 mm, Spannfutter mit 57,15-mm-8-Gewinde-Trägerplatte, 4-200 mm Spannbereich mit T-Schlüsselschrauben, HT300-Material, für Holz-Metall-Drehmaschinen

Very good tool, runout was only .002 thousandth installed out of box. Very good for what I use it for. Neighbor bought a 4 inch to expand centrifugal clutches , I had to machine jaws thinner for unique tool use. The 4 inch was so nice it caught my attention so I ordered a 6 inch to put on one of my small lathes.

The chuck seems solidly made. When I went to mount the provided mounting plate using the provided screws they wouldn’t match up. I tried every combination of screws in each hole and turned the plate completely around. The end result is I retapped the threads and used better screws to get it aligned. Works good now

Hola, el mandril no lo recomiendo para nada. Al abrir o cerrar el mandril se atasca, tuve que desmontarlo entero para limpiar las virutas de mecanizado y limar todas la arista ya que tenían rebabas, aun así no se abre ni cierra con suavidad, incluso lubricando todos los elementos. Lo peor es que la parte trasera del mandril es de plástico, la concentridad varia en unos 0.5mm.

the chuck comes with so much swarf in side it it had to be completely stripped and cleaned once all cleaned and lubed up it works great if my apprentice did not clean up job I would say something hope it lasts a while as it does the job really good cannot complain

I was disappointed how rough the action was out of the box. Although it was very well oiled externally, when I disassembled it to determine why it was so rough I found surface rust on the scroll and the bottom of the jaws. After removing the rust and lubercating internally and softening rough edges with 2000 grit sandpaper it operated more smoothly. It runs true and I would probably buy it again. Just a little bit disappointed in the initial quality out of the box.

It’s a nice Chuck for the money but mine had about 10 thousand runout. I converted it to a front mount set true now it it runs true. The plastic back plate when fully tightened made Chuck jaws very hard to open and close. I had to machine down the thickness to keep plate from rubbing on back plate.

Unfortunately, this chuck arrived with a crack in the chuck body. Make sure you thoroughly review it before use. Submitted a request for replacement or credit and have yet to get a response.

won't fit, when i tried to ask questions was sent to a charge a fee for an answer who then referred me to another, more expensive fee-for-answer service ------this is totally and exactly the way NOT to do business

Zeer slechte kwaliteit , krom en niet uit te klokken. Jammer. Weggegooid geld.

We made a mistake and purchased a 10 inch chuck which ended up being to big. So we returned it paid the return trip purchased a 6 inch replacement and you Charged me a 60.00 return fee? I will take my business somewhere else cause you people are bad