Kundenbewertungen für VEVOR 19 L Vakuumkammer Edelstahl Vakuum Entgasungskammer (Durchmesser 28 cm, Höhe 30 cm) Unterdruckpumpe Vakuumkammer Ideal zum Stabilisieren von Holz und Entgasen von Silikon, Harz, Polyurethan

wow ,, I wish I had bought this yrs ago. I process my own pot to make rick Simpson oil and the vacuum process help remove the remaining alcohol without overheating the oil. it's super easy to open and close. I'm sure you could experiment with freeze drying food with this. the lid for this thing is one heavy flippin piece of glass

Nutze die Kammer zum Trocknen von Gewürzen, Paprikaschoten (kleingeschnitten) etc über einer Schüssel mit wasserfreiem Calciumchlorid, und selbst nach 3-4 Tagen ist das Vakuum noch stabil bei ~30 mbar. Zur Langlebigkeit kann ich noch nichts sagen, da ich es erst seit ca. 1 Monat verwende

Good product. Holds vacuum well. Only issue was finding fittings to match those on the hose. I already had a very good vacuum pump.

The top on this is glass not plexi that’s why it’s so expensive honestly, I’m blown away. It is huge in this photo. I have 16 pounds of pork tenderloin in it marinating to make jerky. if you’re look in the background, everything is Vyve. Maybe I’ll get a promotional prize or something.

parfaitement correspondant à mes attentes. Le montage est très simple, et tout à l'air de très bonne qualité. Je m'en sert pour débuller de la résine ou stabiliser certains bois et jamais déçu. Le nettoyage de la cure au besoin se fait très bien, les joints tiennent bien le choc et les raccords sont toujours parfaitement étanches. Rien à redire.

Funziona correttamente

Ist wirklich beser wi gedacht gerne wieder denke aber das diie lange hält.

This vacuum chamber suits my needs perfectly for casting. Large enough to fit a 16” x 20” piece which is what I was looking for…… and for $350 Cdn, I may just buy another!

Works superb. Almost 0 leak after 24h in vacuum. Better than expected

On receipt, I was not able to get a seal between the lid and chamber without using the small clear split silicone piece on the rim of the chamber. Examination of the chamber top surface showed a small weld line depression that resulted in a leak path. I cleaned and filled the weld line with JB Weld Original epoxy. Now the chamber and orange lid gasket seal very well without the need of the extra clear silicone band. The chamber feels quite heavy duty, as does the 3/4" thick glass lid. The plumbing parts, including the gauge, all sealed well when assembled. The gauge zero'd perfectly when it was 'burped' by temporary removal and reinstallation of the black plug (I don't cut a vent hole in the plug because I often have the gauge upside down and I don't want the glycerin fill to leak). The orange lid gasket does have some less than smooth surface on one side but the other side is smooth all around. The hose connection tends to loosen over time while under vacuum unless well tightened before starting a vacuum run. I am able to pull a gauge reading of 26.5 in Hg at 4000' altitude and, with the valves closed and the pump off, hold it without measurable vacuum loss in excess of 48 hours. I am also able to maintain a leak-free dynamic vacuum for as long as I need to keep the pump running (max to date has been 16 hours continuous). After a number of runs (typically 12 hours / run) with stabilization resin (Cactus Juice), I have not observed any degradation in the orange seal or any of the vacuum line components. With the chamber rim leak fix, this unit is working very well for me.