Kundenbewertungen für VEVOR 3-Backen-Drehfutter, φ160 mm, selbstzentrierendes Spannfutter mit 38,1-mm-8-Gewinde-Trägerplatte, 3-145 mm Spannbereich mit T-Schlüsselschrauben, HT300-Material, für Holz-Metall-Drehmaschinen

Haven't mounted it yet because I have to machine a L00 mounting plate. I inspected it for metal chips in the scroll and it was clean and well finished inside. The reversible jaws are well fitted. I will seal up the back plate which is plastic, with silicon where it mates in the center. I have found that to be a great way to keep trash and swarf from being flung out into the scroll and gears.

I have wanted a 6 Jaw Chuck for some time now, when I found this chuck on Vevor I had to buy it. The first job was to dismantle, clean and inspect it and I was delighted that all the parts were clean and well finished. The chuck was easy to set and mount and has around .015mm TIR. Could we please have this offering in a 250mm version with a D11-8 backplate please.

Nice quality chuck for my metal lathe. After fitting had just 1 thou run out on a ground shaft. Not bad for the money.

Muy bueno

ALTA CALIDAD y muy buen precio

El mecanizado y la precisión es muy buena. Lo he montado en mi torno HBM 320x900 sin ningún problema. No obstante, recomiendo desmontarlas las mordazas y hacerles una limpieza a fondo y aceitarlas al vonver a instalarlas. He encontrado restos de virutas del mecanizado bajo las mordazas desmontables, que aunque no evitan que funcione bien, la limpieza el posterior aceitado es muy beneficioso. Asi mismo, he retirado la tapa posterior de plástico y aunque aquí si estaba limpio, he añadido más grasa a los engranajes para hacer la apertura y cierra de las mordazas mucho más suave y agradable.

Je cherchais depuis longtemps un Camlock D1 4 à prix abordable. Les mors sont un peu dur à ouvrir / fermer. Très bonne concentricité, vérifiée au comparateur à cadran et c'est le plus important. A noter : serrage minimal 11mm

tutto ok come descrizione grazie

Sehr preiswertes Futter, robust und gut verarbeitet. Den Camlockflansch kann ich nicht bewerten, habe einen Flansch für meine Maschine gedreht. Die originale Rundlaufgenauigkeit ist für diesen Preis ok (0,07mm gemessen mit Feintaster), durch Nachbearbeitung der Futterrückseite konnte ich das noch etwas verbessern. War ein guter und nützlicher Kauf, kann ich empfehlen.

This chuck was stiff on arrival from leftover machining dust. I disassembled it (easy to do), cleaned all the parts, and reassembled with super lube. The unit is now nice and smooth. Accuracy with a 1/2 in pin gauge chucked is around .001", which is in the same ballpark as the lathe spindle (12x35 Grizzly), so hard to fault the chuck for this application. It was best at one location, so I put timing marks on that position. The unit has a nice range with bolt-on reversible jaws, so very handy for grabbing tubing or other hollow objects.