Kundenbewertungen für VEVOR Trennscheibe Durchmesser 150 mm, Trennplatte Set mit Grundabmessungen Horizontal 180 x 170 mm, Trennplatte Set für Drehtisch Höhe 80 mm, Teilapparat für kreisförmige Schneidarbeiten, Drehtisch

In linea di massima è un buon prodotto. Al modello che ho ricevuto gli devo rifare l’ingranaggio Z40 modulo 1.25 in quanto è decentrato e un taglio della dentatura pessima.

Bien, sauf que maintenant, j'ai besoin d'effectuer un pignon de 51 dents module 0,8 mais il me faut une plaque d'indexation de 51 trous ou un multiple de 51, ce que je n'ai pas; est-il possible d'en acheter uns correspondant?

I looked at second hand dividing heads on ebay for a long time, but they were well worn. In the end I decided on a new unit and wasn't disappointed. Not so certain how long the rapid indexing location pin will last up, but it is easy to replace if it wears. It is a very solid head and suitable for any machine shop, let alone a home engineering workshop. Buy with confidence.

Je viens d'acquerir ce produit qui me satisfait, toutefois la notice devrait etre en francais. Merci de me faire parvenir une notice en Francais

Like most said, you have to take it apart and clean it. Why they add grit to the grease is beyond me. After cleaning it, it worked a lot smoother, very little back lash and about .0005 run out. Only issue, i was using down pressure only to mark graduations on a one inch aluminum knob, i noticed some springiness when i applied pressure (about .015). It's not the chuck or spindle, the whole head moves at the pivot point. I think it's the brass locks, they are cut poorly and don't seat well. The tail stock helped this time but, you can't always use it. If i can't fix it, back it goes. Oh, if you never used a dividing head, don't even open the owners manual, it will only pizz you off. Google it, you will find vids on how to clean and use it. Save the charts in the back of the manual, it dose not tell you what they mean but, you should be able to figure them out later. they are handy short cuts.

Bon produit sauf le mandrin n'est pas un Sanou Délai respecté ( bravo aussi à UPS )et transport gratuit . Très content de mon achat. Quel mandrin 4 mors est il possible de monter ?

correspond à mon attente

Bs-0 Tête De Division Rapide Semi-universelle 5 " 125 Mandrins à 3 Mâchoires Po

produit de qualité et délai respecter ! Bravo Vevor FR

Nach Reklamation, dass die Bohrung an der Frontplatte nicht mit der Gradskala übereinstimmt. Eine Abweichung von 2 Grad hat. Habe Fotos mit eingereicht. Kundendienst schickt eine Mail nach der anderen ohne aussage. Sie schreiben , ich kann auf der Mail antworten . Das habe ich auch getan, aber ohne Wirkung. Nun schreiben Sie mir, da ich angeblich nicht geantwortet habe wollen sie die Reklamation einfach einstellen, kein schöner zug