Kundenbewertungen für VEVOR Magnetheber, 400 kg Zugkapazität, 2,5 Sicherheitsfaktor, Neodym & Stahl, Hebemagnet mit Freigabe, Permanent-Hebemagnete, Schwerlastmagnet für Hebe, Ladenkran, Block, Brett

Magnet was easy to put together and easier to use. The plasma cutter was easy to assemble but did notice some quality errors as the plastic nut on the base of the plasma torch was cross threaded I was able to make that a quick fix though.

Works great handle screw came out pretty easy but other than that haven’t had any issues all around function works great

Works great on 1/4 or thicker 4x8 sheets. Any thinner the sheet well flex and fall. It must be placed dead center. If it's on an angle it will drop it.

Overall, a great value. One concern is that we had two magnets purchased pull tested by third party. Magnets advertise a 2.5 safety factor, which would have a breakaway point of 2200lbs. One of the units tested achieved 1900lbs, the other was 1700lbs. Not a huge concern, as they both tested well above pulling capacity, but we will monitor as they are re-tested every year. Only other concern is lack of spare parts availability. We use magnets on daily basis, so components need to be replaced periodically.

Hab einen Kleiderständer bekommen

I don’t think this is capable of lifting the advertised weight. If it can, then I must be using it wrong. I tried several times to lift a plate vertically, and each time the magnet would slide off. The plate is approximately 400lbs. I also tried to lift the plate flat, and it would hold for a moment then let go. To be fair the metal I am lifting has surface rust so perhaps the metal needs to be clean first. I respect its boundaries and it works well when I do that.

The magnet dosent lift 50kg it is nat holding plate firme and whene whant to lift id dosent hold... i am disapointed