Kundenbewertungen für VEVOR Professioneller Tisch Schraubstock Präzision Schraubstock 76,2 mm Schraubstockklemmen Werkzeugsatz Bankklemme

It's cheap and cheerful, for the money it's bloody good, I ran a dti over it and it was within 0.01mm on X,Y&Z. edges needed easing as many youtube reviews have said, The base was pretty good I ran a stone over it and although not absolutely perfect I wasn't concerned about anything. The jaws I will probably replace as when the vice arrived they were ground flat on the top, I assume once assembled. once taken apart there is no repeatability. I had to jiggle them about a bit to get them back trammed with the dti. but hey ho it's not a Kurt and not a Kurt price. I can't really comment on the swivel base as I only checked for parallelism. for the deg if I wanted accuracy I would use a sine bar anyway. One thing I did notice was 0 deg started underneath the screw, making 90 deg to the side where there is a mark for setting, no problem for me though. I have the vice on the bed with no base, used my own T nuts and bolts as they were better. For the money it is very good value in my opinion, and would not hesitate in purchasing another should the need arise .

Très bon étau massif et plutôt précis vue le prix .peut être un peut trop gros pour mon usage, mais vue le prix il ne faut pas hésiter

Deze spanvijs doet wat moet , voor de prijs moet je het zeker niet laten, ik heb deze gekozen met draaitafel want die kan er gewoon eraf en misschien later eens gebruikt worden als die echt nodig is het prijs verschil is dan ook miniem vergeleken met deze zonder draaitafel!

I needed a vise a little bigger than the 3.5" one which I have for my RF30 mill/drill (full ballscrew/ cnc conversion)and this is perfect. I especially like the included guide lugs, they make swapping the vise on and off the table a snap with minimal trueing needed. Speaking of which, the swivel feature makes trueing it to the table a snap and does not appear to affect the rigidity. I like it so much and the quality is such that I just ordered one of your 5" dividing heads. Just a note that by purchasing direct from Vevor I saved over $50 over purchasing through Amazon!

Muy contento con el tornillo de banco.El precio es inmejorable y espero que dure mucho tiempo.Lo recomiendo cien por ciento.

Auch hier wieder ein unschlagbares Preis- / Leistungsverhältnis ! Benutzte ihn für unsere CNC Portalfräsmaschine, aber auch für unsere große Ständerbohrmaschine.....Verarbeitung ist einfach Top !

Really good value for money. I bought two of these, that I can use together for long parts. For the work I am doing, these are good enough.

Alles super, Ich arbeite oft und gerne damit und kann den Schraubstock weiterempfehlen. Sehr günstiger Preis und schnelle Lieferung.

I also acquired the compounded milling table from Vevor. The two work well together allowing me to make maximum use of my drill press. This is about as precise as anyone would need for a home workshop. I am now quite satisfied with my drill press set up and see no further need to upgrade.

Very good value for money, the 6" is a beast and on the slight big side for 21cm milling table, but it works fine, I am very satisfied.