Kundenbewertungen für VEVOR Gabelverlängerung Stahl Gabelstapler 1000kg Tragfähigkeit CAT1 /CAT2 Montage 78x61x25cm Palettenwagen 20kg Hebepalette 3-Punkt-Anschluss Geeignet für alle Transport- und Speditionstransporter

Received the item and the bolts needed for the lower link were missing instead there were pins. This absolutely is incorrect I had to buy additional bolts to use for the lower link

The center bar broke right away other than that work well

Kinda bulky, Used on my Backhoe loader probably over did it but bent one fork at the weld trying to lift some logs I cut up Good for light duty IMO but not 4000 lbs a Chevy weighs 3600 lbs LMAO

It work

Item came as pictured, when unboxes i seen the box profile was 3mm wall, i expected 5-6mm wall for the rated weight it should handle, i will be welding on some flat to the sides for extra strength. The first time i used them the bolts to tighten to the bucket bent due to the gap allowing too much movement. I again will need to modify the gap and update the bolt size. Nice idea for a product but in my opinion as standard only fit for very light use.

The 3 point hitch pallet fork might actually work well, but I wouldn’t know because the box was so destroyed by ups when I received it that all the hardware pins were missing. I’m sure they are rolling around in the back of an ups truck somewhere, but that doesn’t do me any good. I’ve contacted VEVOR twice about this and was told both times someone would contact me within 24 hours, but I have yet to hear from anyone.

Broke first use - the tab holding the pin for 3pt hitch folded while sliding the forks into a pallet. The original welds didn't penetrate the metal.

Good product for the price and they work well. Only complaint is they do slide around your tractor bucket and don’t stay straight even when secured well.

Overall, product seemed to be a good product until however, I found the hardware used to tighten the forks to the bucket inferior because the "flange nut" intended to hold the forks firmly simply stops turning when it touches the buckets edge and the threaded rod it's attached to only applies pressure over a very small area and doesn't keep the forks from rotating out of alignment. In addition the crossbar intended to also help keep the forks from moving sideways is only held tight by a wingnut too small to tighten sufficiently to keep bar and forks alligned. I purchased this product to assist in picking up small limbs and branches around yard but proved to be insufficiently capable of staying aligned thus too much trouble without actually welding the forks to the crossbar.

I bought my forks about a month ago, when I received the box it was torn up and one of the yellow plates was missing. When I put it on the tractor, one of the screws was cross treaded and extremely hard to tighten. Other that that, quality is awesome and very well made. I would buy them again.