Kundenbewertungen für VEVOR Gabelverlängerung Stahl Gabelstapler 1000kg Tragfähigkeit CAT1 /CAT2 Montage 78x61x25cm Palettenwagen 20kg Hebepalette 3-Punkt-Anschluss Geeignet für alle Transport- und Speditionstransporter

Let's just start start by saying I'm a welding inspector by trade and have been for the past 15 years. Upon initial examination, I noticed that some of the welds were of lower quality. And I hook this thing up to my tractor lifted 800 lb give or take $50 and one of the welds broke. It wasn't actually the weld that broke. It was at the toe of the weld and the heat infected zone. The base metal used looked to be of poor quality after examining where the steel tore apart at the toe of the weld. It almost looked like it was cast metal but obviously it's not. I'll get around to a welding it up eventually. But just be prepared to fix the damn thing if you buy it

Warped within minutes picking up a log probably 1500lbs. Doesn't stay attached well. Cheap steel and clamps are not any good

The middle support broke the first time I used it. I was very dissatisfied.

I love Vevor. I’ve bought many products from them and it’s all been great but I was disappointed in these pallet forks. The crossbar weld snapped on the first time I used them.

Ok

Broke in first 20 min of use.

I would not trust these forks especially for what they’re rated for. I only got an hours work out of them before one buckled and I had them on a 30hp tractor that might pick up 1700lb In the bucket. Sent email to vevor waited two weeks of automated responses to get a reply that they would reimburse me $27. I thought I would be budget friendly and buy these but would have been better off to just buy better quality to begin with. I do not recommend these forks unless you brace them out of the box. I will not buy anything else from this company or recommend to anyone.

They didn’t last to finish one job

They clamp onto the bucket but sometimes they slide around and you have to keep adjusting them. They actually just broke yesterday to pick up some metal. I don’t think they’re rated for 2000lbs capacity. The metal was Mabey 500 at most.

The forks I bought for the tractor bucket only came with one bolt to tight it down on for each fork. It’s supposed to have two and it’s been very hard to get a hold of somebody to send me the other two bolts not sure which route to go next please help