Kundenbewertungen für VEVOR Diesel Standheizung 12V 2KW für Auto Wohnmobil Boote Lkw Wohnmobil Bus(mit LCD-Schalter & 1 Luftauslass)

Muy bien producto calidad precio Sencillo de usar Y de momento sin problemas La bomba de gasoil un poco ruidosa pero por ese precio no me puedo quejar

Love the heater, but it can be tricky to get working as the display is very dim. Even shaded, if it's a bright sunny day, it's almost impossible to read. Once running, this puts out enough heat to raise the temp in my 2-car, very not-insulated garage by a good 15 degrees. With the two ceiling infrared heaters I've also got, it can get nice and warm even in below freezing weather. It would be absolutely perfect if the display were brighter.

Easy to set up

Hyvä tuote

Das Gerät macht an sich was es soll, der Aufbau ist aber leichter gesagt als getan. Die Frischluftzuvor könnte besser platziert werden, ebenso einen Adapter für Betrieb mit einer regulären Steckdose (12V/15A). Ebenso ist der Standard Warmluftschlauch sowie Abgasschlauch zu kurz.

Fast delivery, nice price, got it install in half an hour and Im not even that good. Would buy again.

the eksos pipe is to sort to get trough walls. Walls today has 20cm insulation with panels on both sides (the wall is between 25 and 30 cm thick)

This diesel heater is very affordable and cheep to run but after only 4 weeks the fuel pump stopped working so I will have to get a replacement pump as the heater is still under warranty

foarte bun

Hi, Just purchased this 2kw Diesel Heater for my 18ft Caravan. Installation and supplied accessories are of reasonable quality with a quiet pump and fan. It all started first time however when I switched to thermostat mode Room Temp was displayed and I was able to set the required room temp. (20c) with the original ambient room temp being (15c). Heater went thru startup cycle then began to heat the room. The temperature got to 20c and just kept climbing without any regard for the preset max of 20c. It just kept climbing to over 30c. The Thermostat was displaying the room correct temperature and the preset remained at 20c. I could shut the Heater down by pushing Off and it went into its cool down mode almost immediately so the controller should be capable of holding a preset temp but fails to even try to throttle back. There must be a faulty controller or something causing this. Please let me know how to fix this issue! I don't think it is a programing problem? Please help Thanks in anticipation of some warranty support Greg Belsar